Recent content by Mito-Maniac

As the title says im after a seller for a poly bush kit for the almera preferably just a rear one for now as my rear ends got more bounce than a kangaroo due to knackered bushes.. Thanks in advance Dave

yeh but when you take the key out n get out the car their still on :S

come to pick up my new gti and the sidelights are stuck on even with the switch off is this a common issue or some stupid fault ?

I think the bonnets gonna stay just for that !!! providing i can get the time off work should make it to the North meet too now !!

Yup i have, mines gonna cost me more than that to sort out as every time i go to do a job on it i find something else thats bolloxed and needs replaced/fixed so im gonna take the bits from mine that that needs plus i have a brand spanking new wing on mine with no rust so thats that fixed... I...

LMAO !!! your so caring and considerate !

Pls dont ridicule this car i just brought it !!! just need to arrange picking it up :) had enough hassle with my GTI so just gonna take the good bits from mine n scrap whats left as its pushed me tooooo far lol !

its the rear section i need tho the bit with the flappy air vents n where the bumper mounts not the actual arch..

aye i dont need wings just the rear arches because the arse end of my car is rotten and there is no way i can fab a panel/patches up to sort it so these are the answer i think :)

The ones im looking at are £6 each at the mo didnt wanna announce it on here incase some one got to them before i could lol but they have the section that i need to repair the rear end of my car where its rotted away (the bit under the end of the bumper :(

I have come across a set of rear arches for a 5 door almera that states 1998 model it also states that it fits a 3 door to, I was wondering will these fit my P reg gti 3 door ? as mines a 1996.... Thanks in advance kinda need a answer ASAP so i know wether to try n buy them :) Thanks Dave

Got my eye on some new panels.. the flaky stuff under the bumper isnt too bad tho so i will clean that up, re weld any mounting points that are needed then clean it all up treat it and paint/underseal :)

The actual welding wont cost me a penny just panels/metal to weld in and the front arches are fine as is most the body work.. i dont mind it taking time and unfortunately i spent a few quid before discovering this lot :S

Well my rear bumper was held on by hopes and dreams and i took it out the way to make removing the old exhaust system easier and fitting the powerflow catback i got from SRI_Alan... anyways took the bumper off and well it practically fell off... i was wondering am i best trying to get a...

Cheers, sounds about right :)