Richs Autech

D2.jpg


you need wheels that colour
 
i'd personally re-flow the first, second and fourth pins from the left of the bottom row, apart from that it looks ok, none of the traces look burnt or lifted so it should be fine
 
Well guys looks like no ones us perfect looking at Hallys board. But will be home for 4 and we will all see then if it works or not
 
Fucking hell Chris, did he use a shovel to solder yours? Thats shocking, not to mention the leads bent inwards.

Rich, as Phil has said, 1,2 & 4 on the bottom row need resoldering. But dont use any old gas iron, you need a proper soldering station that heats to around 400*F.
 
apart from the bent pins hally's doesn't look too bad, most of what you see is just flux, and the ic looks to have had a sticker/heatsink on it that's been removed, but silicone can take a fair bit of heat so that's not a worry either
 
ok so only a little update but its something that was annoying me now for a few months
IMG_0166.jpg

IMG_0167.jpg


old ones were getting worn so replaced with some which were in better condition
 
Back
Top Bottom