Search results

Buy wheels that fit.

Can either heat up and remove the lense to allow you to remove the orange globe, or using some needle nose pliars break it up through the bulb hole removing the pieces, then use a silver bulb which will flash orange.

It's a very common problem, and unless genuine parts are used people have had pattern kits fail again within a few thousand miles... With the price of the cars you have to weigh up if it's worth the cost of replacement.

impressive. but what does it all weigh?

the filler plug was manufactured too low on the box, so you cannot put enough oil in, causes the failure of the box, incredibly common issue and a known fault, no guarantee a replacement box wont suffer the same fate.

unfortunately the forum just doesnt have the traffic it once used to, you're about 5 years too late. Social media has killed forums, try asking on the Facebook groups.

The centres are the correct size, as I mentioned above. Almera disc Clio disc

fuel will be your limiting factor with the ignition timing if the compression is too high. what is the comp of the motor?

yes

Very cool, only thing that lets it down (for me) is the headlights, could do with a set of GTi or VZR's

What is the minimum wheel size you can fit with those extended ball joint lower arms?

Good car

there is a reset procedure, as long as everything is plugged in as it should be. https://almeraownersclub.com/threads/n15-airbag-light-reset.38884/ can take a few attempts

yes, it made the same power as a GTi

http://www.carimports.co.ke/nissan-lucino-srv-vehicle-specifications

That's probably down to the gearing and weight difference between the cars more than anything else. Is the idle of the car smooth? This is my old Autech Pulsar, you can hear there is a noticeable lope to the idle

As it's a low port engine I think it will be around 140hp. I'm led to believe the SRV got the Autech styling parts not the engine. The highport Autechs had quite a lumpy idle due to the cams used.

That looks to be a Crazy Hornet front bumper that is a replica of the R33GTR, the proportions to really lend to the N15 imo

Clean base to work with. Is the idle lumpy at all? Or have a lope to it?

Rota Grid-V