Sr20de fuel pressure reading ?

[Prim gt]

I have just fitted my gauge today ready for when i get a AFPR,my reading at tickover is 2.5 bar,when i rev the engine it goes to 3 bar,is that how it should be ??


Thanks.

 

[Liam]

Yes.

 

[Sam]

now remove the gauge, you shouldnt have it fitted all the time.

 

[Prim gt]

So when i bump up the pressure to 3.5 or 4 bar,is that for when the engine is at tickover ? Is that how a set afpr ?

 

[chunky]

So when i bump up the pressure to 3.5 or 4 bar,is that for when the engine is at tickover ? Is that how a set afpr ?

Depends what you want from the car? are you going to do another dyno run? and have you got a Wideband lambda sensor so that you can monitor if it begins to run rich?

 

[CoV]

It rises when you use throttle as the vacuum disappears. Set the fpr pressure by removing the vac pipe that acts on it with the engine running.

 

[Prim gt]

The vac pipe being the little breather one ?

 

[Liam]

No the 12mm one.

 

[Prim gt]

Ok chaps,thanks so far.

 

[Prim gt]

Another question can anybody give me a link to the correct fuel rail adapter for sr20de ? ,i have just purchase a Sard AFPR

Cheers.

 

[Hally]

http://pages.ebay.com/link/?nav=item.view&id=370260781734

-phone-

 

[Prim gt]

Thanks again Hally.

 

[Prim gt]

Paid for,on its way along with the sard FPR

 

[Liam]

Is the sard blue?

 

[Prim gt]

No,its sliver why ?

The sellar says its not a cheap chinese copy,so all is good hopefully lol

 

[Spook]

No,its sliver why ?

The sellar says its not a cheap chinese copy,so all is good hopefully lol

Oh the seller said it was ok. Must be legit then.

 

[Liam]

How much was it then?

 

[Prim gt]

Cost me 40 quid,retail price is around 90 quid,I got it today in the post,its very nice well made FPR tbh.

 

[Liam]

A fake then.

 

[Spook]

A fake then.

The sellar says its not a cheap chinese copy,so all is good hopefully

Can't be Leem. Seller says it'll be fine.